Power cord with Hubbell 30A 250V 3 phase 4 wire plug included
Tested, see last 6 pictures in the "... other images" link above
Time in statistic screen is in seconds.
On power-up 25 pin user port is always active, use AE BUS command 14 to change to host mode. The control mode setting is stored in volatile memory, so it will need to be set each time unit is powered up.
Windows 2000 Virtual Front Panel software available.
Full P/N: A3L3L000CA140D111A
Output frequency: [3] 13.56 MHz
Power output: [L] 1500 W HALO
Input voltage: [3] 208 V 3 phase w/o breaker
Package: [L] on board, int. rack mount, 4 handles (LED w/4H)
Panel: [0] none(on board, frame mount)
Serial I/O: [0] default (RS232 w/AEBus)
Serial port 2: [0] default (none)
Analog I/O: [C] exclusive option #1
Output Impedance: [A] 50 Ohm (default)
On-board RF con: [1] utilities end
Output Connector: [4] HN
RF Measurement: [0] directional coupler
AC Power Input: [D] Harting Type Han-Q (16A)
Pulsing: [1] pulse option
CEX: [1] CEX option
H2O Fittings: [1] 3/8 NTP female
Custom Config: [A] standard configuration
Manufacturer link https://www.advancedenergy.com/en-us/products/plasma-power-products/rf-plasma-generators/apex/
